The Acoustix loudspeaker brings a level of room placement flexibility not before seen in this type of Krix design.
The dual front ports make this speaker the perfect choice for use in TV cabinets and custom joinery, eliminating ‘boomy’ bass qualities found when using rear ported speakers in this type of application. The Acoustix can be used as the basis for a high quality stereo system, or add the matching Graphix centre channel to the mix to deliver precise timbral matching to the Acoustix mains / rear channels. An acoustically intricate experience.
Krix has managed to produce a small speaker that can provide a seamless sonic picture and that excels at reproducing detail and resolution of complex and dense music mixes. The Acoustix’s tonal balance is dead neutral and this combination of drivers presents a very detailed sonic picture with delicate low level information and clear and natural sounding instruments.
– Australian HiFi – Australia
Frequency Range: 50Hz – 20kHz in room response
Power Handling: Maximum 120 watts RMS amplifier power
Sensitivity: 89dB for 2.83 volts at 1 metre
Configuration: Point source dual 5 inch 2-way
Bass Driver(s): Fibre reinforced moulded polymer baskets with 2 x nominal 130mm (5″) doped paper cones. 25mm (1″) voice coil wound on high powered aluminium former, with vented magnet assembly.
Tweeter: 26mm (1″) dual concentic diaphragm with wave guide centre plug for controlled directivity. Neodymium magnet.
Crossover Points: 2.1kHz
Impedance: 8 ohms nominal (minimum 4.3 ohm)
Enclosure Type: Bass reflex, front vented with internal / external flaring
Dimensions: 450mm high x 180mm wide x 300mm deep (including grille)
Material: 17mm MDF with internal bracing
Finish: Vinyl or lacquered timber veneer
Volume: 14 litres internal
Weight: 10kg each (including grille)